1997 Honda Prelude Turbo

1997 Honda Prelude 
Black 
5 Speed
123,783kms on the body
500kms on the motor (Over $16K invested in the engine alone.)

$11000 obo (Will also consider trades for a bike, RC51 SP2, 10-15 R6, 07-08 R1, 14-15 Z1000, 09-up GSXR1000. 08-10 GSXR750 )

The “BAD”
– The car does not have A/C or P/S. Both were removed during the build as the car was going to be built for big power numbers but plans changed. I do not have the parts to put them back in but if you choose to you can pick them up cheap from a wrecker.
-There is no current AirCare on the car (it’s been off the road for 3 years) and I will not be driving it other than on a permit so AirCare would have to be taken care of by purchaser (AirCare will be gone at the end of the year, and even if you fail AirCare you can still insure for 3 months)
– There are a few small dents/scratches on the car but nothing significant and most not even noticeable until pointed out (I do detailing so I’m very picky about cosmetics)
– Currently, there is no deck in the car. It is still wired for a stereo but I have not bothered to put one in yet. I’m having one installed in the car within the next week or so.

Head/Intake
Skunk 2 74mm Black Series Throttle Body
Skunk 2 Pro Series Intake Manifold
Skunk 2 Spring Base Kit
Skunk 2 Titanium Retainers
Skunk 2 Alpha Valve Springs
Skunk 2 STD Valves
Skunk 2 Black Series Billet VTEC Solenoid
Skunk 2 VTEC Solenoid Cover
Skunk 2 Billet Cam Seal
Skunk 2 Billet Oil Cap

Block
Darton Sleeved H22A (closed deck block)
JE 9:1 Forged Pistons
SCAT Connecting Rods
ACL Race Series Bearings
ARP Head Studs
ARP Main Studs
Cometic Head Gasket
KS Tuned Balance Shaft Delete Kit
KS Tuned Manual Timing Belt Tensioner
Honda Timing Belt
Honda Oil Filter
Greddy 3 Row FMIC
Greddy TDO5/06-18G Turbo
Greddy Case Manifold
Custom Downpipe
2.5″ Exhaust

Transmission
Stock 5 speed (non-LSD)
Fidanza Flywheel
ACT Clutch

Cooling
Skunk 2 Radiator Cap
Samco Silicone Hose Kit
Full Metal Radiator

Suspension/Wheels
H&R Sport Springs
OE Struts
18″ Drag DR-18 wheels
2 new tires up front

Electronics
Hondata S300 V3
Hondata Jumper Harness
Hondata 4BAR MAF (not installed but included)
Hondata Boost Control Solenoid (not installed but included)

Motul oils only. 
Honda Coolant

This has been a 3 year long project for me but life has changed since the build started. The motor is completed as far as I want to take it. Plans were for huge numbers but with a new family member and a new house and job and….its time to let this one go.